Turn the pages on your Kindle remotely with Arduino
As seen here, Alex Mikes enjoys reading his Kindle in bed at night, but prefers to use a stand rather than hold it in his hands. The one disadvantage to this is that one normally has to lift his or her hand up to change pages. Thanks to a clever bit of engineering, Mikes only has to press the button on a small RF remote, signaling an Arduino Nano-based robot to press it for him.
The device uses a micro servo motor to actuate the fake finger, which swings into the correct position to advance pages on command. A 3D-printed frame holds everything in place, and in order to properly control his Kindle’s capacitive touchscreen, a wire is wrapped inside the stylus tip and connected to the circuit ground.
Not since Rick and Morty’s butter-passing robot has there been a more hyper-specific, purpose-built device than perhaps Alex Mikes’ automatic Kindle page turner. Instead of having to raise his arm to tap the edge of the screen while reading in bed, a simple click of a wireless remote makes the attached contraption do all of that hard work for him.
More photos of the project are up on Imgur.
Leave a Reply
You must be logged in with your Arduino account to post a comment.