iPhone, Arduino & Flash CS5

Davide Gomba — May 12th, 2010

[Martin Lihs] connected the iPhone to an Arduino via bluetooth and a socket server in between. No code supplied yet. We’ll check it out for you 😉

You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.

Dave Says:
May 12th, 2010 at 15:13:26
This could be used to add GPS to an iPod or iPad! That would be an awesome hack if it was made fit inside the case and run off the battery.
Connor Says:
February 10th, 2011 at 22:52:22
Do you have any source code for this? And what programs did you use for your iPhone half of this?
d.gomba@arduino.cc Says:
February 11th, 2011 at 10:36:24
Hi Connor,
As it’s written in the post, there were no code supllied on the blog where I found this project.

Thanks for commenting
Davide
Mark Says:
March 26th, 2012 at 18:57:34
I actually think this is using Wifi, not bluetooth. Note that in the video, the “bluetooth” indicator isn’t present in the top status bar on the phone. Other people around the ‘net seem to have reached a similar conclusion, FWIW.