DIY safety-goggles for every maker

Priya KuberMay 15th, 2012

Not using an Arduino, yet a very useful must-have on every maker’s table. Of course not as awesome as a real safety glass, but then, it is a nice start.

Materials required: An empty, washed 2 liter soda bottle, an elastic band, a pair of scissors, a permanent marker.

All you have to do is cut off the top and bottom of the soda bottle, then cut through the remaining plastic to turn it into a single plastic sheet. Then hold the plastic sheet around your face and draw the goggles with a plastic marker. Cut them out, attach the elastic band to both sides, and you’re done!

For detailed instructions, please proceed to the original post at Make.

Via:[Make, Lifehacker]

Leave a Reply

You must be logged in with your Arduino account to post a comment.

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy